We go through a 32-Point Safety Check & A/C Tune-Up process to ensure that your system is receiving the utmost care to keep it running smoothly. Call Us Today! Below are the steps involved in our AC tune-up checklist:
32-Point Check-Up
- Blower Motor: Measure amperage and voltage for proper operation
- Thermostat: Test for proper operation, calibrate, and level
- Air Filter: Clean existing (as needed)
- Bearing: Inspect for wear and lubricate
- Coil: Inspect indoor coil if accessible
- Confirm proper return air and size
- Condenser Coil: Visual inspection
- Refrigerant: Monitor operating pressures
- Safety Devices: Inspect for proper operation
- Electrical Disconnect Box: Inspect for proper rating and safe installation
- Electrical Wiring: Inspect and tighten connections
- Contactors: Test/inspect for burned, pitted contacts
- Electrical: Inspect for exposed wiring
- Capacitors: Inspect and test
- Fan blade: Visual inspection
- Condenser Coil Cleaning: Remove debris
- Service valves: Inspect for proper operation
- Measure Supply/Return temperature differential
- Ductwork: Inspect for energy loss
- Compressor: Monitor, measure amperage and volt draw and wiring connections
- Check Unit for Time Delay Relay
- Check Unit for Isolation Pads
- Suction line: Inspect for proper fittings
- Fittings: Inspect all for signs of oil and/or leakage
- Check lines and fittings with Freon leak detector
- Balance and re-torque blower wheel
- Check Home for proper airflow
- Test condensate drain line
- Check evaporation for coil protection
- Check and test high voltage fuses
- Check and test low voltage fuses
- Check for safety issues